Ads Security FA700KP-ADS Guide d'installation télécharger pdf (Page 16)

FA700KP-ADS Installation and Setup Guide

4–2

FA700KP-ADS Initialization

Power Up

When initially powered, the screen displays the boot sequence as it is

performed. After it is determined what services are available, the

screen displays the Set ECP Address screen.

SCREEN ACTION

If the system is incorporating only one

FA700KP-ADS, leave the address set to 1

and press the OK button. The boot-up

process will continue until completion.

If there are to be additional FA700KP-

ADS units in the system, refer to the

How

to Change the ECP Address

paragraph.

How to Change the ECP Address

After enabling addresses in the control panel using an alpha-keypad,

power up each FA700KP-ADS one at a time, and set its address to

one of the addresses you enabled in the control panel. If this is a first

time power-up of the unit, follow the initialization procedure in this

section. Otherwise, access the Central Station screen then follow the

procedure to change the address on the unit.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

Pas de commentaire

Ads Security FA700KP-ADS Guide d'installation Page 16